Vw mkiv clutch kit installation instructions mkiv clutch kit the ecs tuning clutch kit is a lightweight replacement for the factory-installed vw mkiv dual mass flywheel. the single mass flywheel conversion kit bolts directly to the crankshaft without modification, and comes with. Install the release plate, retaining ring, and clutch disc. use special tool vw 547 or equivalent to center the clutch disc. install the flywheel, tightening the bolts one or two turns at a time in a crisscross pattern to prevent distortion. tighten the bolts to 15 ft. lbs. (20 nm). install the transaxle.. Thomas p.o. box 83041 4827 kingsway burnaby, bc v5h 0a4 canada exovcds swag: http://1060461.spreadshirt.ca/ rate, comment, share, subscribe, let the ads play....
Vw jetta mkiv stage 1 clutch kit installation under the hood es125 things to remove or disconnect under the hood • shift cable support bracket • gate selector cable (remove snap clip) • gate selector relay lever (remove nut and pull lever from shaft) • vehicle speed sensor (vss) electrical connector (unplug). Among our vast inventory of volkswagen parts we carry a huge selection of vw cables including vw bug clutch cables and vw bug accelerator cables. we also offer vw beetle speedometer cable to body seals and vw beetle heater cable seals in addition to the vw beetle cables themselves.. Vw clutch cable, beetle, ghia 1961-1971, 2260mm long vw clutch cable adjusting wing nut the clip is tapped down with a hammer and bent over the chisel to complete the installation. the accelerator cable can now be hooked up to the pedal. we now have a roller pedal and a heavy duty cable that require a small bolt and a few nuts to hold the.
